|
DAC type: Dual mode USB and analog (via CS5343 ADC) wireless DAC
|
|
Inputs: USB audio and minijack analog
|
|
Outputs: Minijack analog
|
|
D/A Converter: CS4344
|
|
Analog ADC: CS5343
|
|
Full scale output: 1.0Vrms
|
|
Output impedance: 470 ohms
|
|
Power source
-Sender: USB from computer or adapter
-Receiver: USB power adapter
|
|
Power requirements
-Sender: 5V, 180ma
-Receiver: 5V, 150ma
|
|
SNR: 95db
|
|
THD+N: 0.01%
|
|
Crosstalk: -65db
|
|
Frequency response: 20Hz to 20KHz, +/- .2db
|
|
Input bit depth: up to 16 bits
|
|
Input sample rate: up to 48KHz
|
|
Wireless range: >100ft
|
|
Latency: <20ms
|
|
Receivers supported: up to 3
|
|
Product dimensions:100x30x10mm (LxWxH)
|
|
Included accessories
-minijack cable (20″)
-minijack to RCA adapter (12″)
-USB power adapter
|
|
Environmental
-Operating Temperature: 32 to 95 degrees F
-Non-operating Temp: -4 to 113 degrees F
-Relative Humidity: 5% to 95% non-condensing
|
|
Advantages of wireless
The W3 wireless system transmits bit-perfect PCM-stereo simultaneously to up to 3 receivers. Because the USB controller in the Sender and the DAC in the Receiver are segregated by the wireless subsystem, various anomalies which plague many wired DACs such as jitter, grounding, and induced cable noise are greatly reduced. In addition, the W3 allows the user to physically isolate a potentially noisy computer from the sensitive audio components in your system.
|
|
W3 USB
The W3 utilizes the TI CC8520 PurePath™ USB wireless system-on-a-chip solutions, TI’s newest offering to the wireless audio arena. The Sender can be powered directly from the USB bus or from the included external power adapter.
|
|
W3 DAC
The W3 Receiver utilizes the CS4344 DAC, a solid, well regarded industry mainstay. Due to the CS4344’s’s high signal-to-noise specs, the W3 presents impressive low noise and low distortion characteristics.
|
